P072C - OBD Trouble Code

<<See All OBD Codes

The fault code P072C can be identified as Stuck in Gear 1. Now when we drive our vehicles, there are a lot of modules as well as computers monitor and adjust a vast number of components and systems in order to make the vehicle's operation seamless as well as effective. Automatic transmission is one out of those components as well as systems.

It is always good to learn more! So, have a look at some more information about the P072C trouble code. The transmission gear is monitored by the transmission control module. This trouble code would be set by the TCM when the transmission would be not at the gear which has been commanded by the TCM.

What causes this problem with the Stuck in Gear 1?

• Transmission control module harness might be opened or shorted
• The transmission hydraulics might be block
• Unwashed automatic transmission fluid (ATF)
• Some complications related to transmission
• Inoperative shift solenoid
• There can be a little automatic transmission fluid (ATF) level
• Distorted transmission valve body
• Transmission control module might have some flaws
• There can be poor electrical connection in the transmission control module circuit

1. Automatic Transmission Sensor - Did your mechanic just found out that there is some fault in the Automatic Transmission Sensor? Buy top notch Automatic Transmission Sensor from us at economical prices.
2. Automatic Transmission Filter - A broken Automatic Transmission Filter can cause a lot of issues. It would be nice if you get it replaced on time.
3. Automatic Transmission Fluid - Everything is fine with the engine control module and still OBD code P072C flashing? Then there is definitely some fault with the Automatic Transmission Fluid. Get it checked and replace if needed.
4. Auto Transmission Shift Solenoid - Auto Transmission Shift Solenoid is an important car part which should never be neglected. May be there is some fault in it due to which P072C code may start flashing.
5. Powertrain Control Module - A faulty Powertrain Control Module can be troublesome. You can always rely on us as we have best auto parts for our customers.
6. Auto Transmission Control Module - If everything is alright with PCM, then there is surely some defect in Auto Transmission Control Module. Get it replaced before the situation gets worse.
7. Auto Transmission Valve Body Kit - P072C code can display due to some issues in the Auto Transmission Valve Body Kit. So, it is very important to replace the Auto Transmission Valve Body Kit with us at equitable prices.

Our main motive is to achieve customer satisfaction as for us our customers are everything and that’s why we will help you to diagnose P072C code by mentioning some major symptoms below:

Common Symptoms

• Irregular vehicle speeds
• Decrease in the power
• Vehicle might be motionless
• Leakage in the automatic transmission fluid
• Divergent engine noises
• Reduced throttle response
• Vehicle speed might be restricted

If you wish to correct this fault code, then you have to follow certain steps. Correcting a problem needs your careful attention. Here are some ways with the help of which you will be able to correct the OBD Code P072C:

• Repair or replace the faulty automatic transmission fluid (ATF)
• Recondition the quirky transmission control module
• You must fix the issue of low amount of automatic transmission fluid (ATF) level
• Restore the grubby transmission valve body
• Rebuild the mechanical issues in the transmission
• The defective shift solenoid should be mended
• Quirky transmission hydraulics should be replaced
• Replace the transmission control module circuit
• Repair the transmission control module harness

However, if you face any issue then we have stocked a wide range of best priced TCM, automatic transmission fluid (ATF), Obd2, Obd2 Scanner, Obd2 Bluetooth, Car Diagnostic Tool, Car Scanner, Transmission Jack, Transmission Oil, Manual Transmission Fluid, Scan tool, Honda Transmission Fluid, Oil Dipstick and more to help you out in fixing your car.

Here are some steps which you should follow in order to diagnose this fault code:

Make sure that you carefully verify the integrity of your automatic transmission fluid. A dipstick can be used to check the level of the A/T with the vehicle running and in park. This method varies a significant amount between manufacturers. A service manual in the dash can be used to find the information with ease or sometimes it is even printed on the dipstick itself! Just make sure that the fluid is clean and free from debris. If you do not remember ever doing a transmission service, then you can always inspect your records and service your transmission accordingly. You will be amazed to know how grubby ATF can affect the functionality of your transmission. It is very important to check ATF level on flat surface to obtain accurate readings.

The fluid which is recommended by the manufacturer should always be utilized. Did you just see some leaks? If your fluid is low, then it means that it is surely going somewhere. After that you should carefully inspect your driveway for any signs of oil stains or puddles. You never know that this might be the issue. Either way, it's a nice idea to address this as well. After that it is important to inspect the transmission control module for any damage. If it is located on the transmission itself or any other location where it may be subject to the elements, you should take a look to find if there are any signs of water intrusion. This could most definitely cause a problem like this, among possible others. Any signs of corrosion on the housing or connectors will indicate that there is some problem. If everything checks out up to now, based on your OBD2 scanner capabilities, then the gear position should be detected and its functionality should be verified. It can be detected if your transmission is shifting or not by its mere drivability. Do you have it floored and its speed is increasing moderately? Then there are chances that it might be stuck in a high gear (4,5,6,7). Are you able to accelerate quickly yet the vehicle's speed never goes as swiftly as you'd like? Then it would mean that it is stuck in a low gear (1,2,3).