Error Code P082A: What It Means & What To Do?

<<See All OBD Codes

A Gear Lever X Position Circuit Range/Performance is an appropriate definition of the OBD-II Code Powertrain Control Module (PCM) failure. It is the Gear Lever Position Sensor that guides the engine computer (PCM) about the gear the transmission is in. If the PCM receives an improbable signal from the gear lever position sensor, the code P082A is stored.

The engine computer (PCM) is informed by the gear lever position sensor about what gear the transmission is in. Generally, the sensor is installed in the shift lever. The code P082A is set once the gear lever position sensor transmits a dubious signal to the PCM.

What causes this problem with the Gear Lever X Position Circuit Range/Performance?

• A defective gear lever x position sensor
• Open or short-circuited harness in the gear lever x position sensor
• A weak or bad electrical connection in the gear lever x position sensor circuit

1. Transmission Parts - Facing the error code P082A? An inferior quality transmission can always be hazardous for the system also it is one of the primal causes behind the occurring of the error code P082A. Tune into Parts Avatar for supreme quality transmission at economical prices.
2. Sensor - hate the halts as much as we do? Well, get your damaged sensor changed from Parts Avatar. What are you waiting for? We are just a click away!
3. Powertrain Control Module - Abbreviated PCM; this is an integral control unit. So, a defective one should be changed immediately.
4. Fuel Metering - In order to accurately fix your error code P082A, you should make amendments to get your fuel metering right in place.
5. Engine Timing Parts - The engine timing should be taken care of and should be fixed in order to avoid the complications caused due to the error code P082A.

Our main motive is to achieve customer satisfaction as for us our customers are everything and that’s why we will help you to diagnose P082A code by mentioning some major symptoms below:

Common Symptoms

• A transmission shift shock
• An illuminated engine light (or a service engine soon warning light)

If you wish to correct this fault code, then you have to follow certain steps. Correcting a problem needs your careful attention. Here are some ways with the help of which you will be able to correct the OBD code P082A:

• A thorough visual inspection should be performed of the wirings and harness in the gear lever x position sensor. All corroded or damaged ones should be replaced or repaired.
• A defective gear lever x position sensor should be restored or repaired.
• Amendments should be made of the poor electrical connection in the gear lever x position sensor circuit.

However, if you face any issue then we have stocked a wide range of best priced transmission, sensor, PCM, fuel metering, engine timing, fuel injectors, fuel injector harness, body control module, injection pump, fuel injection kit, fuel injection tester, fuel injection conversion kit, diesel fuel injectors, transmission control module, electronic control module, engine control unit, engine harness, performance fuel injectors, brake control module and more to help you out in fixing your car.

Want to diagnose the error code P082A accurately? Well, here listed are few steps that you should follow in order to diagnose the error code P082A

To begin with, the mechanic will use a scanner (code reader) or a digital ohmmeter that are the two tools essential for an accurate diagnosis of the code P082A. The transmission range sensor determines the gear the transmission is placed in. If the voltage appears to be absent, then a circuit issue should most likely be observed. Consequently, a weak or poor electrical connection may be observed too. It could be due to either an open in the ground or battery voltage for which a digital volt/ohmmeter should be employed to check for continuity and resistance in both the circuits. All the corroded, damaged or loosened electrical components can further lead to worsening the code as well as the system. While diagnosing it is highly recommended to refer to manufacturer’s specification manual. Also, in order to ensure a precise diagnosis, the system should be reexamined and the vehicle should be test driven in order to make sure the code has disappeared completely.