P0181 - OBD Trouble Code

<<See All OBD Codes

The P0181 fault code can be defined as fuel temperature sensor ‘A’ circuit range/performance. Are you facing some issues with the ambient temperature sensor "A"? Some defects in the fuel temperature/composition sensor? Or is there a programming error in the powertrain control module? If the answer to all these questions is a YES, then you must be prepared because trouble code P0181 is soon going to appear.

Want to learn more about fault code P0181? The P0181 is a generic OBD-II code which would start appearing when the fuel temperature sensor ‘A’ circuit would go out of specifications during the process of self-testing. This would indicate that the sensor voltage has fell below or went above calibrated limit specifications during the self-test.

What causes this problem with the Fuel Temperature Sensor A Circuit Range/Performance?

• There can be some issues with the ambient temperature sensor "A"
• Some defects in the fuel temperature/composition sensor
• The intake air temperature sensor might be faulty
• The wiring connectors might be open, shorted, or damaged
• Powertrain control module programming error

1. Fuel Temperature Sensor - A broken Fuel Temperature Sensor can cause a lot of issues. It would be nice if you get it replaced on time.
2. Oil Pressure Sensor - Everything is fine with the Fuel Temperature Sensor and still OBD code P0181 flashing? Then there is definitely some fault with the Oil Pressure sensor. Get it checked and replace if needed.
3. Powertrain Control Module - A faulty Powertrain Control Module can be troublesome. You can always rely on us as we have best auto parts for our customers.
4. Diagnostic Tools - Willing to purchase some top-notch diagnostic tools online? We are here at your service.

We care for our customers and that’s why we can totally understand your problem. That’s the reason why we have listed out some major symptoms behind the flashing up of OBD Code P0181. They are mentioned here as follows:

Common Symptoms

• There can be some issues due to which the vehicle won’t be able to start if the fuel is frozen from extreme cold or there is water in the fuel
• The vehicle will not start or may lose power and stall if the fuel gets too hot and boils off
• Malfunctioning of the sensors if excessive additives in the fuel cause erratic sensor readings and cause the fuel to boil off at lower temperatures
• The engine control module sets code P0181 to memory and check engine light would start illuminating 

Learn the ways with which you can correct this trouble code:

• The fuel temperature sensor should be tested and you can always replace it if it is out of specifications
• A defective connector or wiring to the sensor should be repaired or replaced
• Replacing a defective engine control module
• The diesel fuel heater assembly with the temperature sensor should be replaced

However, if you face any issue then we have stocked a wide range of best priced coolant temperature sensor, fuel tank pressure sensor, fuel sensor and more to help you out in fixing your car.

If you want to diagnose the faults in the FTS circuit and FTS, then you must use digital volt-ohm meter and an electrical wiring diagram and repair manual. The FTS is situated in the fuel tank, as part of the fuel sending unit, or practically anywhere else, before the fuel injectors, in the fuel system. You can always check your manual for the precise location of the FTS. It would depend on the location of the ECM and FTS you may have to work to get at their connectors, such as if located in the fuel tank under the seat. One can start this diagnosis from the ECM or from the

FTS, it would all depend on what can be easily accessed.

• You will face an issue in starting your vehicle if the fuel is frozen from extreme cold or there is water in the fuel
• The vehicle will not start or may lose power and stall if the fuel gets too hot and boils off
• There can be malfunctioning of the sensors if excessive additives in the fuel cause erratic sensor readings and cause the fuel to boil off at lower temperatures
• The P0181 fault code would be set by the engine control module to memory and would start illuminating the check engine light

Common Mistakes When Diagnosing The P0181 Code

• A visual check of connections to the sensor should be done to make sure they are making good contact to the fuel heater and fuel temperature sensor
• The fuel for excessive additives should be checked properly that can cause sensors to malfunction
• If you find out that the vehicle is in an extreme cold environment, then you must move to a warmer area to allow the vehicle to warm up, then the system should be retested