Bras de contr�le avec joint � rotule by DELPHI - TC2250

Control arms manufactured by Delphi are tested to the extreme for dimension, material, sturdiness, and performance. The control arms are made to imitate the stress as the part will experience on the road. For example, all the components are tested on the three-axis test rig. The test analyzes braking force, cornering force, and suspension travel movement for up to 250,000 cycles. Delphi also tests its product under extreme environmental situations and harsh materials. Delphi?s environmental chamber can test components to a temperature of low -40�F and up to 248�F. To calculate the outcome of salt on the bushings adhesion, all control arms are salt-sprayed and checked after 720 hours. All these tests prove the control arm will perform at its best, even in the toughest situations. The dipping or spraying phosphate process to apply coating is outdated and is also unsuccessful. For this Delphi uses modern technologies. It uses electrical currents to apply the water-based cataphoretic coating, which is proven to be very effective. The long-lasting environmentally friendly method gives maximum rust protection up to 10 years? from salt, dirt, and water.

• Control arms manufactured by Delphi are robot welded for consistent performance and quality
• The best compatibility between the OE and aftermarket part
• Undergo 100% crack detection and ultrasonic flaw detection tests
• Materials match OE specifications
• Anti-corrosion protection applied to each part
• Tested for consistency and toughness