Error Code P0545: What It Means & What To Do?

<<See All OBD Codes

The error code P0545 can be defined as o2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1). The P0545 code means that the powertrain control module or PCM has triggered the code because it detects a fault in the exhaust system gas temperature sensor circuit.

The P0545 code would indicate that there is some default in the exhaust system gas temperature sensor. The voltage variations in the sensor are detected by the powertrain control module, which it reads as exhaust gas temperature.

The air to fuel ratios or the ignition timing is then adjusted to cause the exhaust gas temperature to lower in order to protect the catalytic converter. Now if it would determine that there are variations in the voltage outside of the vehicle manufacturer’s programmed levels, it would then trigger the P0545 error code.

What causes this problem with the o2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)?

• Use of aftermarket and off-road exhaust systems may create back pressure
• The terminals and connectors might be broken, burnt, corroded or loose
• Issue of internal short in the exhaust gas temperature sensor
• There can be some faults in the sensor
• Problem of extreme exhaust leak upstream of the sensor

1. Powertrain Control Module - The P0545 code can also arise due to some issues in Powertrain Control Module. So, it is advised to replace them as soon as possible.
2. Exhaust Muffler - Do you remember when was the last time you got your car Exhaust Muffler checked up? A damaged Exhaust Muffler can cause a lot of issues like displaying P0545 code.
3. Oxygen Sensor - Oxygen Sensor is an important car part which should never be neglected. May be there is some fault in it due to which P0545 code may start flashing.
4. Air Fuel Ratio Sensor - Is your Air Fuel Ratio Sensor damaged or broken? Don’t worry as we have solutions for all your problems.
5. Engine Control Module - Defective car Engine Control Module can be a major reason why P0545 code depicts. So, make sure to replace it online so that you don’t have to face any further issues.
6. Catalytic Converter - Everything is okay with the Engine Control Module and still OBD code P0545 triggering? Then there must be some defects in Catalytic Converter. Replace them as soon as possible.

Willing to know some common symptoms of OBD Trouble Code P0545? Your wish is our demand. Have a look at them below:

Common Symptoms

• Appearing of the check engine light

If you wish to correct this fault code, then you have to follow certain steps. Correcting a problem needs your careful attention. Here are some ways with the help of which you will be able to correct the OBD Code P0545:

• You can always repair or replace the electrical components and then retest them
• Correct the flaws in the sensor
• There can be extreme exhaust leak upstream of the sensor, so make sure that you get it repaired properly
• Replace the exhaust gas temperature sensor
• The PCM’s continuity can be tested, and it can also be replaced as per the requirement

There is no need to be anxious as Parts Avatar – Car Parts Online is here to help you out! We have high grade Ohmmeter, Egt, Exhaust catalyst and a lot more for our precious customers.

If you want to easily diagnose this fault code, then all you have to do is to follow the steps which are mentioned below:

To diagnose the P0545 requires an OBD-II scanner, and mechanic or technician will first clear the codes and retest

Then the next step would be to do a visual inspection of the connections and wiring, first replacing or repairing anything that is shorted, corroded, lose or damaged

Retest and if the code remains, they will then do an inspection on the sensor and all of its circuitry, especially any components near the heated areas of the exhaust system

They may repair or replace damaged components and then use their ohm meter to check the sensors voltage. They may use a heat gun to check the sensor and replace it if needed. They may also test the PCM for system continuity and resistance, replacing and reprogramming if needed

Common Mistakes When Diagnosing The P0545 Code

• Mechanic might make a mistake that both the oxygen sensors as well as exhaust gas temperature sensors are contained in a single unit
• The P0545 error code can trigger up because of some faults in the exhaust sensor and a mechanic might make a big mistake of replacing the oxygen sensor