P0695 OBD Error Code: Problem & Solutions

<<See All OBD Codes

The trouble code P0695 can be defined as Cooling Fan 3 Relay Control Circuit Low. This diagnostic fault code is a generic powertrain code, which means that it would apply to the OBD-II equipped vehicles. The specific repair steps can vary as it depends upon the vehicle make and model.

If an inappropriate level of voltage would be detected by the powertrain control module in the electric cooling fan control circuit, then the P0695 trouble code would start appearing. The level can be sometimes too high and on the other hand sometimes extremely low.

What causes this problem with the Cooling Fan 3 Relay Control Circuit Low?

• Bad electrical connection in the fan 3 relay circuit
• Malfunctioning fan 3 harness
• Inoperative engine control module
• Fan 3 circuit poor electrical connection
• The fan 3 relay might be damaged
• There can be opened or shorted fan 3 relay harness

1. Auto Transmission Shift Solenoid - OBD Code P0695 can appear because of faulty Auto Transmission Shift Solenoid.
2. Electronic Control Unit - There can be some issues with the Electronic Control Unit due to which you may see P0695 code appearing over and over again. Visit us to buy best quality Electronic Control Unit online.
3. Radiator Fan Assembly - Are you facing some faults in your griffin radiator? Don’t worry and get them replaced or else P0695 code can turn up.
4. Engine Control Module - Common cause behind this P0695 error code can be some fault in Engine Control Module. So, it will be a good decision to replace them now.
5. Electric Cooling Fan - Engine Control Module is perfectly fine but still but having that trouble code P0695 flashing? In such a situation your Electric Cooling Fan might be faulty. Why don’t you think of getting that replaced?
6. Powertrain Control Module - The P0695 code can also arise due to some issues in Powertrain Control Module. So, it is advised to replace them as soon as possible.
7. Automatic Transmission Sensor - P0695 code does not really end up spoiling your Electric Cooling Fan, but it might also accompany few Automatic Transmission Sensor issues. We have best Automatic Transmission Sensor with us.

It is essential to know the symptoms of an issue as only then you would be able to solve the problem. So that’s why we have listed out some major symptoms of OBD Code P0695 here:

Common Symptoms

• Engine can start warming up
• Appearance of the check engine light

If you wish to correct this fault code, then you have to follow certain steps. Correcting a problem needs your careful attention. Here are some ways with the help of which you will be able to correct the OBD Code P0695:

• You should replace the fan 3 relay
• If there is an opened or shorted fan 3 relay harness, then it should be repaired or replaced
• Correct the poor electrical connection in the fan 3 relay circuit
• Make sure to repair or replace the engine control module

Parts Avatar Canada is here to solve all your issues related to car parts. We have stocked a wide range of best priced northern radiator, solenoid car, shift solenoid, electric radiator fan, pressure control solenoid, pcm computer, car cooling fan and a lot more to help you out in fixing your car.

If you want to easily diagnose this trouble code, then you must follow the steps which are mentioned here as below:

• The error code P0695 can be diagnosed by using an OBD-II scanner, digital ohm meter and an infrared thermometer
• Diagnosing this can be somewhat challenging without knowing the manufacturer's specs regarding cooling fans for the engine and the air conditioner
• After that a scanner is used by the mechanic or technician to activate the engine fan and check voltage and grounding of the fan motor. No voltage means the system fuses must then be tested, and if the fuses are acceptable, the fan relay must be checked

The voltage at the connector must be within parameters of the manufacturer. The engine temperature readings must then be tested and if not within the manufacturer specs, it is likely a defective engine coolant temperature sensor. Generally, the source of the code would be revealed by the series of tests. Then the mechanic will repair an open or shorted circuitry as detected by the diagnostics before rechecking with the scanner

Common Mistakes When Diagnosing The P0695 Code

• Malfunctioning powertrain control module
• Problems related to the wiring
• Failure in the engine cooling fan control module
• Engine cooling fan might be faulty
• Engine cooling fan relay failure

P0696 - Fan 3 Control Circuit High