P0077 - OBD Trouble Code
OBD Code P0077 - Intake Valve Control Solenoid Circuit High Bank 1
Are you facing
some issues with your variable valve timing solenoid? Is there any sort of
defect in the wiring harness? Or is powertrain control module causing some
issues? If the answer to all these questions is a YES, then your vehicle is
definitely facing intake valve control solenoid circuit high issue or we can
also say that it has OBD P0077 error.
Learn More about OBD Error Code P0077
The
P0077 is a fault code which would start triggering up if there is some issue
with the Bank 1 intake valve control circuit. This code appears when the engine
control module has tried to control the intake valve solenoid and has found
high readings in the circuit. The check engine light would start illuminating
by the ECM until the sensor reads normal range of values.
What causes this problem with the Camshaft Intake
Valve Control Solenoid Circuit High (Bank 1)?
- The
control solenoid may have open circuit
- The issue of short to power
- There can be some faults in the
engine control module
Replace/Repair These Parts To Fix OBD Code P0077
- Variable Valve Timing Control Solenoid - OBD Error Code P0077 can simply be due to
faulty Variable Valve Timing Control Solenoid. Replace old and damage
components now!
- Engine Wiring Harness - Did your mechanic just found out that there is some fault in the
Engine Wiring Harness? Buy top notch Wiring Harness parts from us at economical
prices.
- Powertrain Control Module - P0077 error code also relates to problems with the Powertrain
Control Module. Find all the PCM related parts with us.
- Diagnostic Tools - Willing to buy a new diagnostic tool? Don’t Worry! Visit us and solve your problem.
Symptoms Of OBD Error Code P0077
It is
essential to know the symptoms of an issue as only then you would be able to
solve the problem. So that’s why we have listed out some major symptoms of OBD
Code P0077 here:
Common Symptoms
- The
engine control module may start triggering the check engine light to be
displayed on the dashboard after the out of range sensor reading is found
- The car acceleration may start suffering
- You
may start noticing a decline in fuel economy
How To Correct P0077 Intake Valve Control Solenoid Circuit High (Bank 1)
- The
variable valve timing control solenoid should be
replaced
- The
wiring harness/connectors to the control solenoid should be repaired or
replaced
- Replace
the powertrain control module
However,
if you face any issue then visit us. We have stocked a wide range of best
priced engine performance, intake valve control solenoid circuit,
powertrain codes and a lot more
to help you out in fixing your car.
Easy Diagnosis Of Engine Error OBD Code P0077
- First of all, you must connect a scan tool to
the OBD2 port in the vehicle
- The freeze frame codes should be observed
properly and the condition of the vehicle when the code was actually set
- A road test of the vehicle should be performed
under the same conditions of the freeze frame data
- The you must perform a visual inspection of the
wiring and connectors for any damage or breaks
- You should check for continuity in the wiring
with a Multimeter
- The data stream for the intake control system
should be inspected with a scan tool
- Carefully check for any out of range readings from the sensor
Common Mistakes When Diagnosing the P0077 Code
if you follow all the steps and skip none of
them, then you can easily diagnose P0077 error code. The most common mistake
which people make is to get the intake valve control solenoid replaced without
actually getting it tested. Doing this may or may not solve this issue and then
you will have to perform all the diagnostic steps again without skipping them.