Head Gasket Sets
- Valve Cover Gasket Sets (568)
- Intake Manifold Gasket Sets (558)
- Head Gasket Sets (501)
- Crankshaft Seal (406)
- Head Gasket (405)
- Exhaust Manifold Gasket & Sets (337)
- Oil Pan Gasket Sets (292)
- Plenum Gasket & Sets (292)
- EGR Valve Gasket (213)
- Water Pump Mounting Gasket (213)
- Camshaft Seal (212)
- Timing Cover Gasket Sets (174)
- Bearing Seal Sets (158)
- Timing Cover Seal (146)
About head gasket sets
As a part of the vehicle engine, the head gasket contains all heat and compression generated by your engine. The head gasket's purpose is to secure all chambers of combustion, coolant, and oil between the head and neck, which makes the head gasket a vital joint of the engine. Between head and engine block lies the head gasket. Different manufacturers produce their own head gaskets and you can definitely find a head gasket for your vehicle. No matter what your car needs are, you will find one. Motor oil coolant, motor oil in the refrigerant, and overheating are some of the symptoms.
What is the purpose of head gasket sets?
The head gasket is mounted as an obstruction from leaking into the cylinders to the engine fluids. Among the most critical components are the head gasket for the combustion chamber. Also, the head gasket blocks the oil and water pipes as a barrier to the cylinder.
How head gasket sets works?
To allow the oil to flow freely in the engine, the oil ways between the head and the block must be screened via a head gasket. This also needs to do the same for rivers so that refrigerants can also travel freely around the turbine. However, it also needs to seal the cylinder so that the engine does not lose compression which makes the head gasket special from any other gasket. Within a motor there's a piston going up and down in a circle. The cylinder head is above the cylinder, allowing the fuel and air to be combusted in and the exhaust gases to leave through inlet and exhaust valves. If the piston rises on compression strokes, the air / fuel mixture will escape, creating a lack of friction between the cylindrical head and the cylinder without proper sealing. The head gasket contains steel rings, known as fire rings, which create a tight seal around the top of the cylinder. These are smashed essentially as the cylindrical head is pushed against the engine's base to have a shield that matches the high temperatures and pressure. That's why you always have to lock with the head bolts to the correct torque levels: you can compress too tightly and the gasket will be crushed too much to form a proper seal and it won't seal enough.
Where is head gasket sets located?
The head gasket is a ringing panel between the automotive engine head and engine block. Because of its location between hot and cold engine components, the head gasket experiences different temperatures, from high temperatures of the combustion chamber to sometimes cold temperature of the cooling system. The head gasket can finally carry marks across the surface, as the temperature changes take their toll over time.