Everything You Need To Know About Car Trunk Lights

The trunk light may be a little light bulb that's placed on the highest part of a car’s trunk. Its primary function is to remove darkness from the trunk once the lid would be opened. Since it's rarely used, the trunk light will last for years. However, like every commonplace light bulb, it's at risk of breaking or carrying out because of age or in some cases, because of explosive automobile movements which will break the filament within.

Want to know the location of the trunk light? Then keep on reading further. The trunk light is that the normal, tiny lightweight bulb that's set on the highest portion of your car's trunk.

The trunk light could be a little light bulb that's situated on the highest part of a car’s trunk. Its main role is to remove darkness from the trunk once the lid would be opened.

Do you want to know some frequent problems which might start occurring in the trunk light? Take a look below to know some frequent problems with the trunk light:

• The trunk light bulb might be always on
• Bulb might be dim or flickers
• Trunk light bulb might not work properly

There are a few things which might cause your trunk light to malfunction. Watch for the following symptoms if you suspect a bad trunk light:

1. Light bulb might be dimmer than normal - There can be some cases when these filaments would possibly begin to wear out, which cause the light bulb to burn much dimmer than it might commonly will. There are a lot of automobile owners which do pay attention to the precise brightness of their trunk lightweight, this be-careful call might be pretty simple to note. If you will open your trunk and the light would be burning dimmer than it always will, then you should take the proactive step to get rid of and replace the trunk light or contact a neighbourhood ASE certified mechanic who would be able to complete this project for you.
2. Light bulb might start burning brighter than normal - Now on the opposite side of the equation, there can be some situations where the light bulb would start burning brighter than usual if it would start to wear out. It might be again because of inconsistent flow of electricity which would be inside the bulb when the filaments are brittle, damaged or might even start breaking. If you will face this situation, then there are two things which you should do

• First of all, you can always replace the light bulb on your own which might be not too difficult as it totally depends upon what type of vehicle you have as well as your comfort level while removing a cover from the trunk lid.
• You can always contact a technician to replace the light bulb for you. It can prove to be a great idea if you have a latest vehicle where the trunk light would be contained inside the trunk lid and at the same time it would be difficult to access it.

It is said that a workman is only as good as his tools, and it is definitely true when it comes to the car bodywork. It is vital to have the right tools to repair your Trunk Light Bulb or else a straightforward job would turn into constant headaches. So that’s why we have listed out some invaluable tools below which you will need while repairing your Trunk Light.

• Appropriate replacement light bulb
• Box end or socket wrench (whichever is applicable for disconnecting your battery terminals)
• Flashlight
• Flathead screwdriver
• Gloves

It is true that the brands which we use make a statement about who we are and who we are willing to be in the future. There are a number of car lovers which are emotionally attached with a specific brand for their car parts. So if you are searching for a particular brand for your Trunk Light, then you have arrived at the right place. Have a look below: -

We learn more by looking for the answer to a question. That’s the reason why we are here to provide you the answers for all your questions. Thinking about the related parts of the car Trunk Light? Fear not! Just have a look below: -

• License Plate Light
• Flasher & Parts
• Instrument Light
• Marker Light
• Step & Courtesy Light

More than any other kind of failure in a car, there's almost nothing that's quite as heartbreaking as a completely damaged Trunk Light. Now when we talk about the replacement cost, it might vary a lot even on the same car depending upon its performance, labor cost, brand etc.

Do you want to change your trunk light on your own? Then have a look at the steps of changing the trunk light below:

Part 1 of 2: Removing the old trunk light

Step 1

The battery should first of all be disconnected. A box end or socket wrench should be used to disconnect the clamp holding the negative battery cable to the negative terminal on the car battery.

It would then prevent you from blowing a fuse, but it is also a great habit to develop as a first step to any service or repair which would involve any electrical part on your automobile.

Step 2

After that you should locate the trunk light. The trunk should be popped open with your key or the handle on the driver’s side floorboard to access the trunk or cargo area of your vehicle.

The light bulb might be mounted on the underside of the trunk door itself, or it might be situated on the roof of the inside of the vehicle’s cargo area. Utilize a flashlight if needed to find the light bulb.

Step 3

The trunk light housing should then be removed. Use a flathead screwdriver or your fingernail if you can, and then you should gently get under the lip of the housing along each side. Just make sure that you should be gentle and patient, and the side which would want to come out first will start to come loose.

Warning: There is no need to break the plastic tabs on the housing, as they are very expensive to substitute since they are uncommonly serviced parts. If you break one, then you would have to buy a replacement from a dealership.

Note: There would be no need to remove the housing entirely. There would be wires running to the housing, and these will not allow you to remove it completely without first removing the electrical connector. There are a lot of cases, for this specific repair you only need to pull out the housing enough to access the bulb.

Step 4

The old light bulb should then be removed. Latex or rubber coated gloves can be used to gently pull the light bulb out of the socket. Now if you would be trying to do this with your bare fingers, then the oil which would be there in your hand would make it slip, and there would be chances of you squeezing the bulb too hard and then breaking it, then you would be less likely to cut yourself while wearing gloves.

Warning: Just be very careful that you should not break this bulb. Make sure that you use caution when you would remove the old light bulb.

Part 2 of 2: Installing the new trunk light

Step 1

The light bulb and housing should then be reinstalled. You should use gloves, and then insert the base of the light bulb into the socket of the light bulb housing. Generally there are two basic types of light bulbs which are utilized in this application, but both of them are designed to be installed in either direction.

Type 1 is the same as a household light bulb. These install with either a simple push or with a “push in and twist” motion.

Type 2 has a cylinder shape and it would be connected by two clips or spring-loaded tabs.

Now once the new bulb has been inserted, then the housing into the vehicle should be replaced by gently guiding and then it should be pressed back into place.

Step 2

The battery should be reconnected and then the next bulb should be tested. The negative battery terminal should be slid over the negative post of the battery and then utilize the box end or socket wrench and after that the terminal cable should be tightened up.

Now at this point, the task would be completed, there would be a need to just inspect the new bulb. Even in the absence of keys in the vehicle’s ignition, there should be an operational trunk battery. You should walk around the vehicle and then check that the light has been illuminated.

Then the trunk should be closed, the tools should be cleaned and then your task would be finished.

With all of the components of an automobile, it will be overwhelming once making an attempt to stay up with everything. The lights which would be on an automobile serve a range of various functions and keeping them operating ought to be a priority. Among the foremost helpful lights that are on an automobile are generally placed within the trunk. The general public use their trunks on a routine to try to do things like haul groceries around. If unloading the contents of a trunk in the dead of night, having a lightweight will be very helpful. Whenever that the trunk is opened, this light can return on to illuminate the within this space.

Now just like any other bulb, the trunk bulb can start wearing out over time. Generally, a bulb can get around 4,000 hours before it'll have to be compelled to get replaced. There are a variety of things which will cause these bulbs sporting out quicker. Having an excessive amount of moisture in the trunk will cause the bulb being blown untimely. It you will take out some time to examine the trunk on a daily basis can build it straightforward for you to work out once there's a problem with the bulbs which has to be addressed.

It can be a little difficult to replace the bulb within the trunk of your automobile. The degree of problem concerned are going to be directly associated with the kind of automobile that you simply have. If you are not sure about the way to get the blown bulb out, then you'll need to search out some skilled technician. You should always allow the professionals to handle this kind of task as they will make sure that it is done in the right manner.

Have a look at some of the signs that you will start to notice when it would be time to get the trunk light on your car replaced:

• The light might not be coming on at all
• The light blinks on and off when the trunk would be open
• There would be a black film on the light